Fram® PH9100 Extra Guard® Oil Filter
Engineered for Conventional Motor Oil. Cellulose and Glass blended media provides protection for oil change intervals up to 5,000 miles. 95% filtration efficiency. With an ideal balance of dirt-trapping efficiency and dirt-holding capacity, FRAM Extra Guard oil filters use a special blend of fibers and resin to create a proprietary filter media that delivers excellent engine protection. Extra Guard is the perfect filter for everyday drivers who perform frequent maintenance on their vehicles.
- Engineered for Conventional Motor Oil
- Cellulose and Glass blended media provides protection for oil change intervals up to 5,000 miles
- 95% filtration efficiency
- With an ideal balance of dirt-trapping efficiency and dirt-holding capacity, FRAM Extra Guard oil filters use a special blend of fibers and resin to create a proprietary filter media that delivers excellent engine protection
- Extra Guard is the perfect filter for everyday drivers who perform frequent maintenance on their vehicles
- 2004-1999 Chevrolet/GMC Truck, 2004-2003 GMC & 2004-2001 GMC Truck
Product Specification:
- Anti-Drainback Valve – YES
- Base Gasket I.D. – 3.109
- Base Gasket O.D. – 3.453
- Base Gasket Thickness – 0.047
- By-Pass Valve Setting – 9-15
- Height – 5.094
- Inside Diameter – 13/16-16 Th’d
- Outside Diameter – 3.66
- Style – 1
Installation Instructions:
- Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot
- Place a drain pan under the oil filter and unscrew oil filter
- Clean mounting base making sure the “O” ring from the old filter is not stuck to the filter mount
- Apply film of clean oil to filter gasket. Do not use grease
- Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers
- Check owner’s manual for correct oil specification, viscosity and amount
- Add oil to “full” on dipstick. Idle engine for five minutes and check for leaks
- Shut off engine and recheck oil level after 5 minutes and top off as necessary.
